Before First Use - AEG 49176V-MN User Manual

4. BEFORE FIRST USE

WARNING!
Refer to Safety chapters.
4.1 Initial Cleaning
Remove all accessories and removable
shelf supports from the appliance.
Refer to "Care and
cleaning" chapter.
Clean the appliance and the accessories
before first use.
Put the accessories and the removable
shelf supports back to their initial
position.
4.2 Using the sensor fields
To activate a function touch and hold the
selected symbol on the display for
minimum 1 second.
4.3 Setting the time
You must set the time before you
operate the oven.
When you connect the appliance to the
electrical supply or after a power cut, the
indicator for the Time function flashes.
Press the
time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
5. HOB - DAILY USE
WARNING!
Refer to Safety chapters.
or to set the correct
You can only change the time if:
• The child safety device is not on.
• None of the clock functions Duration
or End is set.
• No oven function is set.
4.4 Preheating
Preheat the empty appliance to burn off
the remaining grease.
Preheat the two ovens. Heat
up one oven at a time.
Set the functions listed
below, if applicable.
1. Set the function
maximum temperature.
2. Let the appliance operate for 1 hour.
3. Set the function
maximum temperature.
4. Let the appliance operate for 15
minutes.
5. Set the function
maximum temperature.
6. Let the appliance operate for 15
minutes.
Accessories can become hotter than
usual. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow in the room is sufficient.
ENGLISH 9
and the
and set the
and set the