Pci And Pci-X Adapters - IBM xSeries 445 Type 8870 Option Installation Manual

4. Install the new power supply:
5. Verify that the dc power LED and the ac power LED on the power supply are lit,
6. Replace the front bezel on the server (see "Removing and replacing the bezel"

PCI and PCI-X adapters

The following notes describe the types of adapters that your server supports and
other information that you must consider when installing an adapter:
v The following illustration shows the location of the PCI-X expansion slots on the
PCI-X slot 6
(133 MHz)
Figure 14. PCI-X slots
v Locate the documentation that comes with the adapter and follow those
v If you need to change the switch settings or jumper settings on your adapter,
v Video adapters are not supported.
v Some long adapters have extension handles or brackets installed. Before
20
xSeries 445 Type 8870: Option Installation Guide
a. Place the handle on the power supply in the open position.
b. Slide the power supply into the chassis and press the handle to the closed
position.
indicating that the power supply is operating properly.
on page 17 for instructions).
PCI-X board.
Note: The illustrations in this document might differ slightly from your hardware.
PCI-X slot 4
(100 MHz )
PCI-X slot 5
(133 MHz )
instructions in addition to the instructions in this chapter.
follow the instructions that come with the adapter.
installing the adapter, you must remove the extension handle or bracket.
PCI-X slot 3
(100 MHz )
PCI-X slot 2
(66 MHz )
Attention LED
Power LED
PCI-X slot 1
(66 MHz )