Bosch KT700VCI User Manual page 11

R
Keep the SSID and the codes for the radio link in a
safe place. Make sure these data are readily to hand
in case faults occur.
R
We recommend a thorough inspection of the pre-
mises on commissioning: Establish where in the
building the VCI works properly and where the oper-
ating limits are.
R
If the VCI is to be used in a vehicle, radio communi-
cation can be severely limited.
R
The radio link is affected by weather conditions. The
reception signal may therefore vary.
R
Please contact your network administrator with any
queries.
�.10.2 �nformationonaccesspoints
A wireless access point is an electronic device, which
acts as an interface between a radio network and a
cable-connected computer network. It provides a wire-
less connection between the KTS 340, the PC/laptop
with ESI[tronic] Startcenter and a printer, for example.
i
We recommend using WLAN standard IEEE 802.11b
(data transmission rate max. 11 Mbps) for the
access point. The "extended range" function is not
supported.
Please note the following:
R
The access point should be located as centrally and
high up as possible, ideally under the ceiling.
R
The access point antenna should face downwards
towards the floor.
R
In the event of a poor connection it may be useful to
change the set channel on the access point. If pos-
sible, avoid using neighboring channels to channels
that are already in use.
R
We recommend that encryption of radio communica-
tions is configured at the access point.
Bosch Automotive Diagnostics Equipment (Shenzhen) Limited
Safetyinstructions|���|11
�.11 SatetyWarning
R
Inspection shall be carried out in good ventilation.
Connect the exhaust pipe to outside if there is no
enough ventilation;
R
Smoking and open fire are prohibited in the inspec-
tion;
R
The battery liquid contains sulphuric acid that could
erode the skin. Avoid battery liquid from touching
the skin directly in operation, especially note that
the liquid shall not be splashed into eye;
R
The engine temperature is high when running. Avoid
touching the high-temperature parts, such as radia-
tor and exhaust pipe;
R
Pull manual brake before starting the engine. Block
the front wheels and place shift lever at P or neutral
gear to avoid accident when starting the engine;
R
If external batter is used as power supply, pay
attention to the electrode; use red alligator clip to
connect anode and black alligator clip to connect
cathode;
R
Keep all the power cables, pens and tools away from
belt or other moving parts if using instrument in
engine compartment;
R
Do not wear watch, ring and loose clothes in mainte-
nance for engine compartment;
R
Wear approved safety glasses in all inspection pro-
cesses;
R
Only the enclosed power adapter or power supply
cable can be used for supply connection;
R
If the equipment is used in a manner not specified
by the manufacturer, the protection provided by the
equipment may be impaired.
���|11 |11 en