Table of Contents
Advertisement
Chapter 4
Setting Up the Server
4.4
Setting the Configuration File (fjpfca.conf)
3
Based on the connection path(s) confirmed in
agement table for the server", enter the instance names corresponding to the physical slot names on
the server into the "target binding table".
1.
From the two tables,
find the same
combination of
physical slot name
and Channel
Adapter as listed in
the path route table.
This completes the target binding table.
4.4
Setting the Configuration File (fjpfca.conf)
Edit the configuration file according to the "WWN instance management table for the server", "WWN instance
management table for storage system", and "target binding table".
For how to set to the configuration file and the setting example, refer to
ters" (page
22).
Check the "WWN instance management table for the server", "WWN instance management table for stor-
age system", and "target binding table" for any omissions.
4.5
Re-checking the Settings
After setting is complete, check for incorrect settings in the configuration file.
1
Use the "chk_conf" command to check for errors.
The settings in the configuration file can be checked for errors by entering the following command:
#/usr/sbin/FJSVpfca/chk_conf -v
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
[WWN instance management table for storage system]
Physical slot name
SERV1_SLOT0
100000000e248434
SERV1_SLOT1
100000000e24846f
[target binding table]
Channel Adapter name
SCSI T_ID
CM0CA0Port0
0
CM1CA0Port0
0
Copyright 2017 FUJITSU LIMITED
Step 2
and the information in the "WWN instance man-
Instance name
WWN
2.
fjpfca0
fjpfca1
Alias name (WWN)
DX400_CM0CA0P0
DX400_CM1CA0P0
14
Record the instance
name in the same
row as the physical
slot name in the
target binding table.
Instance name
fjpfca0
fjpfca1
"Chapter 6 Required Driver Parame-
P3AM-3712-15ENZ0
Advertisement
Table of Contents
