Gilera 633721 Workshop Manual page 62

Electrical system
Turn signals system check
The circuit of the turn indicators is controlled by the electrical control device and the instrument panel.
In the event of a malfunction, proceed as follows:
1. Check the function of the bulbs
2. Check the function of the turn signal indicator switch
3. Without disconnecting the instrument panel, with the key switch in position ON and with the engine
stop switch in position RUN, check for intermittent voltage between terminals 9-ground and 10-ground
of the large 20-pin connector.
If there is no voltage, check the wiring and the correct function of the electrical control units. If the fault
persists, replace the instrument panel.
Lights list
1 High-beam / low-beam headlights
2 Position light / front headlight
3
4
5
6 Helmet compartment bulb
Fuses
The electrical system is equipped with:
1. Six fuses "A" located on the shield back plate
2. Five fuses "B" located in the helmet compart-
3. One fuse of 30A "D" (main fuse), located near
the battery on the left-hand side, under which is
The rating of the various fuses are stamped on the
To replace the fuse, use the gripper provided in the
The table shows the position and characteristics
of the fuses installed in the scooter.
CAUTION
BEFORE REPLACING A BLOWN FUSE, FIND AND SOLVE
THE FAILURE THAT CAUSED IT TO BLOW. NEVER TRY
ELE SYS - 62
LIST OF BULBS
Specification
Turn indicator bulb
Tail light bulb and light
Licence plate bulb
ment
also a replacement fuse.
fuse holders "C".
tool bag.
Nexus 500 euro 3
Desc./Quantity
2 12V-55W, halogen (H7)
2 12V-5W, all-glass
4 12V-10W, spherical
1 12V-21/5W, spherical, twin-filament
1 12V-5W, all-glass
1 12V-5W, cylindrical