Display Modes - ABB REU 610 Operator's Manual

1MRS755770
4.1.3.2.
4.1.3.3.
Voltage Protection Relay
Operator's Manual
1. The backlight is turned on after the relay has performed the internal power-up
tests and entered into the protection mode.
2. The display is tested by inverting it for approximately three seconds, see
Fig. 4.1.3.1.-1.
3. The display is returned to the idle mode and the backlight is turned off if no
operation indication message is displayed. However, if the non-volatile function
is active, a message shown on the display before the auxiliary voltage was
disconnected reappears on the display.
Fig. 4.1.3.1.-1 Display test at power up, display inverted

Display modes

When the display is in the idle mode, the name of the feeder is displayed, which by
default is - ABB -. To change the name of the feeder, use SPA parameter M20.
- ABB
Fig. 4.1.3.2.-1 Display in the idle mode
When the display is in the view mode, you can only view the settings.
SETTINGS
*GRP1
Fig. 4.1.3.2.-2 Display in the view mode
When the display is in the setting mode, you can also edit the settings.
SETTINGS
*GRP1
Fig. 4.1.3.2.-3 Display in the setting mode
Display backlight
Normally the backlight of the display is off.
-
:1.20
:1.2 1
REU 610 REU 610
A040216
A040217
A051574
A051575
17