Audio Setup - SONIQ QPi600B Instruction Manual

Customizing the Function Settings

AUDIO SETUP

1. Press the SETUP button in DVD mode.
2. Select Audio Setup in the main menu using the
3. Select a menu option using the
button.
AUDIO OUT
Select the output sound format corresponding to your system connection.
When making connection to a TV or stereo system via the analog audio
jacks, select PCM or RAW.
RAW: Does not have a Dolby Digital Decode.
PCM: Select when connected to a 2 channel digital stereo amplifier.
• If apply HDMI connection to TV, make sure to select PCM, audio
signal passing to TV via HDMI cable.
VIDEO SETUP
1. Press the SETUP button in DVD mode.
2. Select Video Setup in the main menu using the
3. Select Brightness or Contrast using the
selections and press OK button.
Maintenance
Cleaning the Disc
A defective or soiled disc inserted into the unit can cause sound to drop out during playback. Handle the disc
by holding its inner and outer edges.
• Do NOT touch the surface of the unlabeled side of the disc.
• Do NOT stick paper or tape on the surface.
• Do NOT expose the disc to direct sunlight or excessive heat.
• Clean the disc before playback. Wipe the disc from the center outward with a cleaning
cloth.
• NEVER use solvents such as benzine or alcohol to clean the disc.
• Do NOT use irregular shaped discs (example: heart shaped, octagonal, etc.). They may cause
malfunctions.
Cleaning the Unit
• Be sure to turn the unit off and disconnect the AC power cord before maintaining the unit.
• Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth that has been
dipped in a weak soap-and-water solution and wrung out thoroughly, then wipe with a dry cloth.
• Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. Do NOT use compressed air to remove
dust.
Important Note
Before transporting the unit, remove the disc from the disc compartment.
or buttons.
, , or buttons and press OK
or buttons.
or buttons, highlight your
- 21 -
AUDIO OUT
BRIGHTNESS
CONTRAST