Suspensions
•
Tighten the nut completely.
•
Support the pumping member pin in
order to screw the upper cover.
•
Screw the upper cap on the pumping
member pin.
•
Place the sleeve in the vice using the
specified tool.
•
Screw the upper cover, tightening it to
the prescribed torque.
Specific tooling
AP8140149 Protection for fitting operations
•
Once the operations are completed,
restore the spring preloading correct
value.
Installing the fork legs
•
Insert the fork stem in position.
SUSP - 286
Stelvio 1200 NTX MY11