Advertisement
Model
Serial Number
Date Purchased ............................................................
Place of Purchase.............................................................
IMPORTANT :
To obtain the highest Precision while Spreading:
The Speed sensor must be mounted on a wheel that is not subject to slip or spin during the
–
Spreading.
Wheel pulse distance and spreading width should corectly entered into to monitor.
–
HOLD signal will flash when the spreader is not out putting material.
–
Enter the correct setting for Material Density, Door Height, Rate and Spinner speed, to
–
allow the Field Mate to calculate the correct chain speed to suit the required spreading
rate.
Calibrate the Spreader using the DUMP screen. Feed out one tonne of material and adjust
–
the FLOOR FACTOR as required to ensure the System will spread accurately.
............................................................
............................................................
Copyright
All information contained in this user's guide is the
property of G-Tech NZ Ltd. All rights reserved. This
user's guide may not be , in whole or in part, be copied,
photocopied, reproduced, stored, or reduced to any
electronic medium or machine readable form, without
permisssion from G-Tech NZ Ltd.
Page 2
Advertisement
