Advertisement
Job Menu:
Selecting a JOB:
This is done when a job is to be reset or restarted. A PRO has 16 jobs and there fore selecting
any of these jobs can be done by this method. A Job that has a "XX.XXX.XX" in the date location is an un allocated
job.
1: In the Main Menu scroll to JOB.
2: Quick Press "ON" to enter a JOB. Scroll to JOB using the 5or6 keys.
3: Hold 5or6 to select the job for adjusting.
4: Scroll to SELECT in the JOB SETUP screen Using 5or6. At SELECT hold 5or6 to select the job.
This job will be the current Job that work is logged to. Date and Time renewed . Job Totals and Job Name remain
untouched.
Reset a JOB:
1: In Main Menu scroll to JOB.
2:Quick Press "ON" to enter JOB. Scroll to JOB using the 5or6 keys.
3: Hold 5or6 to select the job for adjusting.
4:Scroll to RESET in the JOB SETUP screen Using 5or6.
5: At RESET hold 5or6 to reset the job. All Totals, Date, Time and Name for this job will be cleared.
Caution: Data cannot be recovered after this event.
Name a JOB:
1: In Main Menu scroll to JOB.
2: Quick Press "ON" to enter JOB. Scroll to JOB using the 5or6 keys.
3: Hold 5or6 to select the job for adjusting.
4: Scroll to NAME in the JOB SETUP screen Using 5or6. At NAME hold
5or6 to name the job.
5: At the NAME job screen 5 will change letter, 6 will goto the next letter
space. A maximum of 11 letters can be entered.
6: Quick press "ON" to exit.
View a JOB:
1: In Main Menu scroll to JOB.
2: Quick Press "ON" to enter JOB. Scroll to JOB using the 5or6 keys.
3: Hold 5or6 to select the job for adjusting.
4: Scroll to VIEW in the JOB SETUP screen Using 5or6. At VIEW hold
5or6 to select the job. Report screen will be displayed.
5 : Use 5or6to scroll through the job report.
6: Quick press "ON" to exit. Viewing job does not unset the selected job.
7: When exiting to the Main Menu, the Job Report is set back to the Current Selected Job Number.
Operate Menu:
1: In Main Menu scroll to OPERATE .
2: Quick Press "ON" to enter OPERATE Mode.
3: Use the 5 to display the following information types:
- AREA
- AREA sub (Reset this by holding down the 5or6 key)
- DISTANCE (Total distance travelled, combines the RUN and HOLD distances)
- WEIGHT of material spread for this job
- RATE, amount of hect per hour are being spread
- SPEED
- Spinner RPM
- Chain Left RPM
- Chain Right RPM
- All RPMs displayed on this screen
4a: Delete the displayed total by holding down5or6 keys for 6 seconds.
4b: In Optional screens holding down the 5or6for 6 sec turns the alarm on/off.
5: Use the 6 key if the"Run Hold Mode" is "Keys", to switch the Field Mate
into/out of Hold.
6: Quick press "ON to Exit to Main Menu.
Page 16
Advertisement
