Advertisement
1: Mounting:
Mount unit were it is easy to operate. Use the Ram mount fitting supplied to set the device in any
position.
2: Connect Cables:
Connect power the unit. Plug the 12 pin plug into the spreader 12 pin plug. These cables and sensors
should be factory connected.
3: Configure the system using the SETUP option screens:
INSTALLATION
Page 11
Set display contrast.
Speed sensor debounce.
Typical set 20%.
Set to Single or double floor
depending on spreader type.
This is distance the spreader
travels every time a wheel
pulse is received.
Spreading width.
Date setup
Help desk phone number
Id of this unit
Setup time
Defines how often the Chain
valve PWM setting is
updated. Set to 2.
Advertisement
