Table of Contents
Advertisement
System expansions
Removing the second hard disk drive
1
1
Installing the hard disk carrier
Plug the data and the power supply connectors into the hard disk drive or into the hard disk
drives.
Lift the hard disk carrier into the system unit in the direction shown by the arrow (1) and push it
forward until it engages (2).
Press the hard disk carrier in the direction of the arrow (3) and press it downward (4).
Close the system unit (see
If necessary, you must adapt the entry for the drive in the Setup menu.
i
40
2
1
2
1
"Assembling the system
Remove the screws (1).
Pull the hard disk drive out of the
carrier (2).
Make the required settings on the
remaining hard disk drive
(e.g. stand alone).
4
unit").
3
A26361-K520-Z100-1-7619
Advertisement
Table of Contents
