Table of Contents
Advertisement
System expansions
1
Push the board into the slot (1).
Ensure that the end of a long board without angle bracket fits into the corresponding guide of
the system unit. Ensure also that the point of the angle bracket slots into guide (a).
Press the board into the slot so that it engages.
Replace the clip (2) which fixes the board. Make sure that the clip engages when released (3).
If necessary, plug the lines on the board.
Close the system unit (see
Removing a board
Open the system unit (see
Remove the lines connected to the board.
Press on the clip in the direction of the arrow (1) and remove it (2).
Remove the board from the system unit (3).
Place the board into an appropriate packaging.
For cooling, protection against fire and in order to comply with EMC (electromagnetic
!
compatibility) regulations, you must refit the rear slot cover plate.
32
2
3
a
"Assembling the system
"Opening the system
1
2
unit").
unit").
3
A26361-K520-Z100-1-7619
Advertisement
Table of Contents
