Table of Contents
Advertisement
8
Use the two screws indicated in the figure to attach the interposer
board to the DVD/CD-RW or CD-ROM drive. See letters "C" and
"D" in the figure.
9
Attach the 44-pin CD-ROM drive cable to the exposed side / back
of the interposer board. See letter "E" in the figure.
10 Slide the DVD/CD-RW or CD-ROM drive carrier into the chassis. See
letter "A" in the figure below.
11 Connect the loose end of the CD-ROM drive cable to the backplane
connector. See letter "B" in the figure.
67
Advertisement
Table of Contents
