Table of Contents
Advertisement
56
drive power adapter cable used in these instructions was sent to
you with your fixed drive kit.
1
Observe the safety and ESD precautions at the beginning of this
book. See
"Safety Information."
2
Power down the server and unplug all peripheral devices and the
AC power cable.
3
Remove the chassis cover. For instructions, see
Chassis Cover."
4
Remove the front bezel if it is installed. For instructions, see
"Removing and Installing the Front Bezel."
5
Align the two holes at the left side of the floppy drive with the
two cutouts in the floppy drive carrier. See letter "A" in the figure
below.
6
Lower the right side of the floppy drive into the carrier until it
clicks into place. See letter "B" in the figure below.
7
Open the connector on the rear of the floppy drive by pulling up
on the connector cover. See letter "A" in the figure below.
8
Insert one end of the 26-pin flat flex cable end into the connector.
See letter "B" in the figure below.
A
4 Configuring the system
"Removing the
B
Advertisement
Table of Contents
