Table of Contents
Advertisement
11 Open the connector on the rear of the floppy drive by pulling up
on the connector cover.
12 Insert one end of the flat flex cable end into the floppy drive
connector.
13 Push down on the connector cover to lock the cable into place.
14 Slide the carrier assembly into the left hard drive bay until it clicks
into place. See letter "A" in the figure below.
15 Open the connector labeled "Floppy Con" on the backplane by
pulling up on the connector cover. See letter "B" in the figure
below.
16 Insert the loose end of the flat flex cable into the backplane
connector. See letter "C" in the figure below.
17 Push in on the connector cover to lock the cable into place. See
letter "D" in the figure below.
63
Advertisement
Table of Contents
