Installing The Battery - UTStarcom C2000 Manual

USING THE BA
USING THE BA

INSTALLING THE BATTERY

1
1
Insert the bottom of battery into the groove at the bottom of
the handset. Then press in the top of the battery until it
snaps.
REMOVING THE BATTERY
1
1
NOTE
The battery must be correctly placed in the battery compartment.
If battery is incorrectly inserted, the handset will not turn on or the battery may
slip out during use.
8
TTER Y
TTER Y
USING THE BA
USING THE BA
CHARGING THE BATTERY
POWER CONNECTION
1
1
Connect the charger to a standard 100~240 VAC Oultet.
LED Indicator : When travel charger is plugged into wall mount, the LED
indicator shall flash Red, Green and Orange in order
within 1second. Connected to the transceiver, the TCU
LED will indicate the charge status of the transceiver
battery pack via the following table.
Off : Transceiver not connected or transceiver connected with no battery.
Flashing Orange : Shorted/Open circuit in cable, phone or battery or
output over current or battery fault
Solid Red : Battery is being charged. Recharging may be active.
Solid Green : Charge cycle is complete (battery is >90% of rated capacity
and, trickle charging may be active) or backup charge may
be active.
Solid Orange: The temperature of battery is abnorma
NOTE
During charging, LED on the phone will be Red color.
After finishing Charging, LED on the phone will be off. And LED on the charger
will be Green color.
WARNING!
In case of instant electric power interruption, the travel charge may not function
properly.
In this case, please disconnect the travel charger from the wall outlet and then try
charging again after 5 seconds.
TTER Y
TTER Y
l.
9