Using The Battery; Installing The Battery; Removing The Battery - UTStarcom CDM8932 User Manual

DISPLA Y INDICA
DISPLA Y INDICA
Speaker Phone
Phone is in speaker phone mode.
GPS Icon
Indicates the Location Service of your
phone is disabled/enabled.
1X
Phone is in the 1x service area.
Network
Phone is in the progress of "UP Browser".
TTY
TTY mode is active.
Voice Privacy
"Voice Privacy" mode.
Phone Lock
Phone is locked.
Ear Jack
A headset is connected.
(Depends on TTY Mode Off.)
Secure
Phone is in "Secure" mode.
Bluetooth
Indicates Bluetooth power on mode.
Indicates Bluetooth discovery on mode.
Data Only
Receives an async. call as a voice call.
Dormant
Indicates the phone is in disconnection
condition while on "Server Connection".
Page 12 - Chapter 1
TORS
TORS
USING THE BA
USING THE BA

INSTALLING THE BATTERY

1. 1 Place the battery on the back of the handset and
slide into place. 2 Push the battery down until it
locks into place. Battery lock latch automatically
locks into place.
NOTE: Make sure the battery is securely placed to avoid
slipping off during a call.

REMOVING THE BATTERY

1. 1 Slide the latch over to the right, lift up the battery
and 2 remove the battery from the handset.
NOTE: If the battery is not correctly placed in the battery
compartment, the handset will not turn on and/or
the battery may detach during use.
TTER Y
TTER Y
Chapter 1 - Page 13