Honeywell UDC2500 Manual page 7

Installation of the 50133058-501, UDC Controller Keypad Button Guide
Kit
Step
1 Remove the chassis from the case.
2 Remove the printed wiring boards from the chassis.
3 Remove the Display/Keyboard.
Insert the button guide over the protruding bezel rubber keypads, aligning with the six
4
bezel tabs as shown in above Figure.
5 Reassemble the Display/Keyboard and the other printed wiring boards.
Reinstall the chassis into the case. Push in hard until the case tabs lock onto the
6
chassis, then replace the screws if present.
January 2017
Action
51-52-33-137 7