Install The A12T3-Share - Accusys A12T3-Share User Manual

3.

Install the A12T3-Share

Follow the steps in this chapter to install your A12T3-Share RAID system.
3.1 Install Disk Drives
Follow the steps below to install your drives.
1. Place the drives with connector align with the edge of the disk tray and secure drive with
screws as below figures.
Four screws for 3.5"
2. Slide the disk tray into the disk bays of the chassis.
3. Push the tray inward until the tray firmly connects and you hear the tray click into place.
4. Repeat for all drives to be installed into the A12T3-Share.
Note
Recommend using drives with same size, speed, model and firmware
version.
User Guide
Three screws for 2.5"
1. Introduction
Page 3-1