Technical Data; Prior To Using For The First Time - AEG Crema Classica Operating Instruction

g

Technical Data

Power consumption: 1220 W
Mains voltage: 220 - 240 V
;
This appliance complies with the fol-
lowing EU Directives:
– 73/23/EEC dated 19.02.1973 "Low
Voltage Directive", including
Amending Directive 93/68/EEC
– 89/336/EEC dated 03.05.1989 "EMC
Directive", including Amending
Directive 92/31/EEC

Prior to Using for the First Time

Before frothing milk for the first time
you should steam through about a
quarter of a tank full of water in order
to clean the heating system. Proceed
exactly as described in the following
section "Frothing Milk" but without
putting milk in the milk container.
Place as large a receptacle as possible
in the middle of the drip grid and
under the milk discharge outlet of the
frothed milk spout (Figure 1/D, J).
Preparation
Warning: only fill the water tank with
cold, clear water. Do not use mineral-
water, distilled water, milk or other liq-
uids!
0 Raise the water tank lid (F).
0 Remove the water tank (G) by the
lid and fill with cold, clear water
(Figure 1).
0 Replace the water tank with its lid and
push down as far as it will go.
Use
You can use the milk frothing machine
to make cappuccino, café au lait and
cocoa or simply to heat up and froth
milk (for example as a drink with
honey when suffering from a cold).
10
Assembling and attaching the
frothed milk spout
(Figs. 1 and 10)
Important: all parts of the frothed milk
spout (Figure 2) must be firmly con-
nected to avoid additional air or milk
being sucked in.
0 Insert the knob for regulating the froth
(Figure 2/Q) into the control valve (Fig-
ure 2/R) and push firmly into place.
0 Insert the control valve (Figure 2/R)
into the connector (Figure 2/O), and
connect the milk discharge outlet (Fig-
ure 2/P) to the connector.
0 Firmly push the complete frothed
milk spout onto the steam nozzle (Fig-
ure 2/N) until the upper red seal ring
(Figure 7/"arrow") is no longer visible
and the steam button (Figure 1/B) can
be pushed down fully.
0 Join the milk container with lid to the
control valve (Figure 1/K, L).
Note: you can also suck up the milk
directly from the carton using the flex-
ible hose (Figure 2/S). Check that the
milk carton does not exceed the height
of the frothed milk spout. The flexible
hose must be inserted down into the
milk carton.
0 To do this, attach the hose to the con-
trol valve and insert the other end of
the hose (cf. Figure 10) into the milk
carton.
Frothing milk
0 Place a cup on the drip grid (Figure 1/D)
under the milk discharge outlet
(Figure 2/P).
0 Switch the appliance on using the on/
off switch (Figure 1/A). The indicator
(red) is illuminated.
When the ready indicator (orange) is
illuminated the milk frothing machine
is ready for use (Figure 1/H).
0 Press the steam button (Figure 1/B)
down fully.
Warning: hot steam will emerge.
Check that the milk container or flexi-
ble hose is attached. If they are missing