Table of Contents
Advertisement
AES-100
This command allows read-only or read-write access. If the IP address is specified, access is allowed for the
manager station with that address only.
SNMP Access Delete command
Syntax:
snmp access delete <community> [<IP addr>]
This command revokes SNMP access by the specified community (password). If the IP address is specified,
access is denied for that manager station only.
SNMP Access Flush Command
Syntax:
snmp access flush
This command revokes access by any and all manager stations.
SNMP Access List Command
Syntax:
snmp access list
This command shows the allowed access.
5.3.2
SNMP Trap Configuration
The AES-100 uses the SNMP trapping facility to proactively report unusual events to one or more trap servers.
To configure the trap parameters, use the
SNMP trap parameters, save the configuration to the nonvolatile memory with the
Trap Add Command
Syntax:
snmp trap add <community> <IP addr> [<port>]
where
<community> =
<IP addr> =
[<Port>] =
This command adds a trap server.
5-4
snmp trap
The password used by the AES-100 to authenticate itself to the trap server.
The IP address of the trap server.
The optional port argument is for specifying the UDP port number on the
server in case it is different from the default of port 162.
commands in the IP subsystem. After configuring the
command.
config save
IP Configuration
Advertisement
Table of Contents
