Table of Contents
Advertisement
2.4
Rear Panel
The following figure shows the rear panel of the AES-100. Connect one end of the power cord to the receptacle
labeled AC INPUT on the rear panel of your AES-100 and the other end to the power outlet. Please make sure
that no objects obstruct the smooth free-flowing operation of the fan (to the left of the power receptacle).
2.5
Port Connections
2.5.1
Console Port Connection
For the initial configuration of your Prestige, you need to use a terminal emulator on a computer and connect it to
the AES-100 through the console port. Connect the 9-pin male end of the console cable to the console port of the
AES-100 and the 9-pin female end to a serial port (COM1, COM2 or other COM port) of your computer.
2.5.2
ADSL Port Connections
The line from the user carries both the ADSL and the voice signals. For each line, the AES-100 has a built-in
splitter that separates the high frequency ADSL signal from the voice band signal and feed the ADSL signal to the
AES-100, while the voice band signal is diverted to the CO port.
To complete an ADSL connection, connect the line from the user equipment to the
the central office switch or PBX (Private Branch Exchange) to the
CO
line are not shorted on the MDF (Main Distribution Frame).
Hardware Installation
Figure 2-2 Rear Panel
CO
User
port and the line from
port. Make sure that the user line and the
AES-100
2-3
Advertisement
Table of Contents
