Aux Operations - Clarion M606 Owner's Manual & Installation Manual

Bluetooth Operations
2. Each time the [ ] button is pressed,
playback proceeds to previous track in the
reverse direction.
Note:
Playing order will depend on Bluetooth audio
player. When the [ ] button is pressed,
some A2DP devices will restart the current
track depending on the duration of playback.
During music streaming playback, "A2DP"
will be shown on the display. Information
about tracks (e.g. the elapsed playtime, song
title, etc.) cannot be displayed on this unit.
When an A2DP device is disconnected, "NO
DEVICE" will be shown on the display and
the unit will return to previously selected
audio source. Some Bluetooth audio players

AUX Operations

The rear AUX terminals of this system is pro-
vided to allow playback of sounds and music
from external devices connected to this unit.
Press [ SRC] button on the panel to select
"AUX".
AUX Input sensitivity setting
Select the following settings to set the sensitivity
level of the sound from an external device con-
nected to this system, that are difficult to hear,
even after adjusting the volume.
* The factory default setting is "MID".
1. Long press the [DISP] button.
2. Press the [ ] button until "AUX SENSE"
appears in the display.
3. Rotate the [UP/DOWN] knob to select "HIGH",
"MID" or "LOW".
Note:
• W hen AUX mode is selected, AUX IN sensi-
tivity can be set.
14
M606
may not have play / pause synchronized with
this unit. Please make sure both device and
main unit are in the same play / pause status
in BT MUSIC mode.
ID3 display
During music streaming playback, for music
information that is longer than the display
panel:
When SCROLL is ON, the LCD will display
ID3 TAG information cyclely, e.g:
ALBUM->TITLE->ARTIST..
When SCROLL is OFF, the LCD will display
one of the ID3 TAG information, the default
is TRACK, but user can adjust it to other ID3
TAG information by press the [DISP] button.