Basic Operations; Adjusting The Volume - Clarion M255 Product Manual

7. OPERATIONS

Basic Operations

CAUTION
!
Lower the volume level before powering the
unit off. The unit stores the last volume set-
ting. If the unit is powered off with the volume
up, when the unit is powered back on, the sud-
den loud volume may harm your hearing and/
or damage the unit.
Turning on/off the power
1. Press the [ FNC ] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [ FNC ] button for 1 second
or longer to turn off the power for the unit.
Selecting a mode
1. Press the [ FNC ] button to change the opera-
tion mode.
2. Each time you press the [ FNC ] button, the op-
eration mode changes in the following order:
Radio mode CD mode
Note:
• If the CD mode is selected when no disc is inserted,
the display shows "NO DISC".

Adjusting the volume

Turning the [ ROTARY ] knob clockwise increases
the volume; turning it counterclockwise decreases
the volume.
∗ The volume level is from 0 (minimum) to 33 (maxi-
mum).
8
M255
Note:Be sure to read this chapter referring to the front diagrams of
chapter "2. CONTROLS" on page 3.
Setting the Z-Enhancer
The unit provides 3 types of sound tone effects,
stored in memory. Select the one you prefer.
∗ The factory default setting is "Z-EHCR OFF".
Each time you press the [ Z ] button, the tone ef-
fect changes in the following order:
"Z-ENHANCER 1"
ENHANCER 3"
HANCER 1"...
• Z-ENHANCER 1 : bass emphasized
• Z-ENHANCER 2 : treble emphasized
• Z-ENHANCER 3 : bass and treble emphasized
• Z-EHCR OFF
Audio mode adjustments
Press the [ A-M ] button to select the adjustment
mode. The mode switches as follows each time
the [ A-M ] button is pressed:
BASS
∗ The display returns to the previous mode 7 sec-
onds after the adjustment.
Adjusting the bass
Radio mode...
1. Press the [ A-M ] button and select "BASS".
2. Turning the [ ROTARY ] knob clockwise empha-
sizes the bass; turning it counterclockwise at-
tenuates the bass.
∗ The factory default setting is "0". ( Adjustment
Adjusting the treble
1. Press the [ A-M ] button and select "TREB".
2. Turning the [ ROTARY ] knob clockwise empha-
sizes the treble; turning it counterclockwise
attenuates the treble.
∗ The factory default setting is "0". (Adjustment
range: -7 to +7)
Note:
• Bass and Treble can only be adjusted when the "Z-
enhancer" is off.
"Z-ENHANCER 2"
"Z-EHCR OFF"
: no sound effect
TREB BAL FAD
range: –7 to +7 )
"Z-
"Z-EN-
Previous mode