Table of Contents
Advertisement
To make sure the Laundry Center is
solid and level, tilt the maclhine forward
so the rear legs are off the ground.
Gently set the machine back down to
allow the rear legs to self adjust. Place
a level on top of the washer. Check it
side to side, then front to back. Screw
the front leveling legs up or down to
make sure the unit is solid on all four
legs (no rocking of the appliance should
e:dst).
C,onnect
exhaust
duct
to outside
ductwork.
Use duct tape
to seal all
joints.
o Do not use screws or bolts which can
catch lint and cause blockage in duct.
• Do not use plastic flexible duct.
Do not exceed the length of duct pipe
or number of elbows allowed in the
Maximum
Length
Chart,
Page
4.
Install the exhaust duct as described in
Exhaust Requirements,
Page 3, and
refer to the drawings below. To exhaust
inside, refer to Alternate
Exhaust
Methods, Page 7.
CORRECT
gEX3f:lR£-Cr
INCORRECT
\\\\\\\\\N
INCORRECT
L
CORRECT
_
INCORRECT
Read
and
save
the
Operating
Instructions
and
the Use
and Care
Guide
that
came
with
the Laundry
Center.
Clean the dryer drum and washer with
a damp cloth.
Turn on electricity
at power
source.
Start
washer
and
dryer,
RUN
THROUGH
ONE
COMPLETE
CYCLE and check for possible leaks,
exhaust connections and tub drainage.
Ensure the burner has lit by opening
dryer door after two minutes ofrtmning
time and noting heat inside dryer.
Page 6
NOT[!: Before burner will light, it is
necessary for the gas line to be bled of
air. If the burner does not light within
45 seconzls the first time the dryer is
turned on, the safety switch will shut
off the bts'ner. If this happens, turn the
timer to "OFF" and wait 5 minutes
befiJre making another attempt to light.
Reinstall access panel.
Alternate installations:
recessed
or closet
area locations.
The tbllowing
are minimum installa-
tion spacings and openings (in inches)
that you should
allow.
For easier
installa::ion
and serwce,
consider
additional spacing.
Dryer
Washer
Advertisement
Table of Contents
