Preparing The Measurement - Beurer BM 77 Instructions For Use Manual

USB interface
The blood pressure monitor also allows you to transfer your
measured values to the PC.
To do this, you need a regular USB cable (included in delivery)
and the „HealthManager" PC software.
The software can be downloaded free of charge from the
download area under Service at www.beurer.com.
System requirements for the Beurer „HealthManager" PC
software
1. Supported operating systems:
• Windows Vista SP1 or later
• Windows 7
• Windows 7 SP1
• Windows 8
• Windows 10
2. Supported architectures:
• x86 (32 bit)
• x64 (64 bit)
3. Hardware requirements:
• Recommended: At least Pentium 1 GHz or faster with at
least 1 GB RAM
• Free memory on the primary partition of at least:
– x86 – 600 MB
– x64 – 1.5 GB
• Graphic resolution from: 1024 x 768 pixels
• USB port 1.0 or later

4. Preparing the measurement

Inserting the batteries
• Remove the battery compart-
ment lid on the rear of the
device.
• Insert four 1.5 V AAA (alkaline
type LR03) batteries. Make sure
that the batteries are inserted
the correct way round. Do not
use rechargeable batteries.
• Close the battery compartment
lid again carefully.
All display elements are briefly
displayed, flashes in the dis-
play. Set the date and time as described below.
If the battery replacement symbol
played, you can no longer perform any measurements and
must replace all batteries. Once the batteries have been
removed from the device, the date and time must be set again.
Any saved measurements are retained.
Battery disposal
• The empty, completely flat batteries must be disposed of
through specially designated collection boxes, recycling
points or electronics retailers. You are legally required to
dispose of the batteries.
25
4 x 1,5V AAA (LR03)
is permanently dis-