ThinkPad P50 User Manual page 89

Table 2. Config menu items
Menu item
Network
USB
Value
Submenu item
Wake On LAN
• Disabled
• AC only
• AC and Battery
Ethernet LAN Option
• Disabled
ROM (for Legacy Only
• Enabled
boot mode or Both
with Legacy first)
UEFI IPv4 Network
• Disabled
Stack (for UEFI Only
• Enabled
boot mode or Both
with UEFI first)
UEFI IPv6 Network
• Disabled
Stack
• Enabled
(for UEFI Only boot
mode or Both with
UEFI first)
UEFI PXE Boot Priority
• IPv6 First
(for UEFI Only boot
• IPv4 First
mode or Both with
UEFI first for boot
capability and IPv6
and IPv4 stacks are
both enabled.)
USB UEFI BIOS
• Disabled
Support
• Enabled
Always On USB
• Disabled
• Enabled
Comments
Enable the computer to power on when
the Ethernet controller receives a magic
packet (a special network message).
If you select AC Only, Wake on LAN is
enabled only when the ac power adapter
is attached.
If you select AC and Battery, Wake on
LAN is enabled with any power sources.
Notes:
• The magic packet type Wake on LAN
requires ac power.
• The Wake on LAN function does not
work when a hard disk password is
set.
Load the Ethernet LAN Option ROM to
enable startup from an integrated
network device.
Enable or disable Internet Protocol
Version 4 (IPv4) network stack for UEFI
environment.
Enable or disable Internet Protocol
Version 6 (IPv6) network stack for UEFI
environment.
Select network stack priority for UEFI
PXE boot.
Enable or disable boot support for USB
storage devices.
If you select Enabled, the external USB
devices can be charged through USB
connectors even when the computer is
in low-power mode (sleep, hibernate, or
power-off).
Note: If you select Enabled, USB wake
up function is not supported on Always
On USB connector.
.
Chapter 6 Advanced configuration
71