Led Indicators; The Setup Program - Unicorn Electronics ENDAT-3201M User Manual

User's Manual

5-7. LED Indicators

The system board comes with two LED indicators on the edge of the motherboard that
indicates the network system status. If you experience any problems with the adapter, first
make sure the appropriate driver is loaded, the proper cable is connected to the RJ-45 port
and the hub complies with the adapter specification, such as 10Mbps 10Base-T or 100Mbps
100Bast-TX. Finally, recheck the LEDs.
FUDUP (Full Duplex) Indicator
When indicator is ON, it indicates Full-duplex mode: otherwise, it is OFF. The adapter
supports full duplex at 10 or 100Mbps. If the switch-hub supports the N-way feature and full
duplex, the system automatically runs in full duplex mode.
Tx/Rx (Transmit/Receiver) Indicator
This indicator flashes to display that there is network activity – indicating transmission or
reception data from the network.

5-8. The Setup Program

The package includes a diskette containing the setup program. This program allows you to
verify the configuration and isolation of faults.
The adapter's I/O port address and interrupt request levels (IRQ) are set by the BIOS. Other
default settings can be changed for situations as shown below.
Problem (RESET8139.exe) provides the following function:
•
Displays the current configuration of the adapter
•
Performs network diagnostic tests to verify the operation of the adapters basic
functions, and the adapters ability to communicate over the network with another
adapter.
•
Provides set up for new configuration to make a change specify settings: Remote
BOOT ROM, Flow Control and Full-Duplex mode Enable/or Disable
Full duplex operation is set automatically if the Full-duplex option is set to Disable. Please
follow the prompt instructions to set-up or change the system configuration.
41