Installing Memory; Shared Vga Memory; Installing Riser Card - Unicorn Electronics ENDAT-3201M User Manual

14

2-2. Installing Memory

The ENDAT-3201M CPU board offers one 168pin DIMM sockets supporting up to 512MB
of memory. The DIMM memory can be 100MHz (PC-100) or 133 MHz (PC-133).

2-3. Shared VGA Memory

The ENDAT-3201M is using built-in AGP VGA controller with share memory architecture
(SMA) - AGP mode with 2MB to 8MB of system memory. The amount of video memory
on motherboard determines the number of colors and the video graphic resolution.

2-4. Installing Riser Card

Installing Riser Card (Max. 3 PCI Slot on Riser Card)
PCI Slot INT ADSEL
PCI 1 A,B,C,D AD24(Onboard LAN)
PCI 2 B,C,D,A AD23
PCI 3 C,D,A,B AD22
PCI 4 D,A,B,C AD21
There are two different riser cards that can be fitted to ENDAT-3201M CPU board. The first
one is a 98pin ISA only Bus riser card (traditional ISA Bus riser card), the second one is a
188pins PCI/ISA riser card.
Please note: PCI/ISA riser cards jumper settings have to be matched with the
motherboard INT/AD-select jumper.
The default INT/AD-select for ENDAT-3201M All-In-One motherboard is listed in the
above table. However, it could be revised by changing JP14 setting for different
INT/AD-select. The following table shows the variable configurations:
INT/AD Configurations:
Expansion for PCI Slot * Close 1-2
Expansion PCI 1 INT =A,B,C,D
Expansion PCI 2 INT = B,C,D,A
Expansion PCI 3 INT = C,D,A,B
Expansion PCI 4 INT = D,A,B,C
Note: Even change the setting for different configuration the AD-select should be match to each INT.
The ENDAT-3201M Embedded CPU Board
Close 2-3
INT = B,C,D,A
INT = C,D,A,B
INT = D,A,B,C
INT = A,B,C,D