Table of Contents
Advertisement
29
User's Manual
Display Device
Select the display device for system. The available options are CRT Only, CRT + LCD.
** Please note that the text form in the CRT+LCD mode will be shown as the format of LCD
mode, not CRT mode; therefore, it will be reading differently on the CRT display.
LCD Resolution
Select the display resolution for LCD panel. The available options are 640x480, 800x600,
1024x768.
PCI Latency Timer (PCI Clocks)
This option specifies the latency timings (in PCI clocks) for PCI devices installed in
the PCI expansion slots. The settings are 32, 64, 96, 128, 160, 192, 224, or 248.
IRQ3/4/5/7/9/10/11/14/15 Assigned to
These options specify the bus that the specified IRQ line is used on. These options
allow you to reserve IRQs for legacy ISA adapter cards. These options determine if
AMIBIOS should remove an IRQ from the pool of available IRQs passed to devices
that are configurable by the system BIOS. The available IRQ pool is determined by
reading the ESCD NVRAM. If more IRQs must be removed from the pool, the end
user can use these options to reserve the IRQ by assigning an ISA/EISA setting to it.
Onboard I/O is configured by AMIBIOS. All IRQs used by onboard I/O are
configured as PCI/PnP. IRQ12 only appears if the Mouse Support option in
Advanced Setup is set to Disabled. IRQ14 and 15 will not be available if the
onboard PCI IDE is enabled. If all IRQs are set to ISA/EISA and IRQ14 and 15 are
allocated to the onboard PCI IDE, IRQ9 will still be available for PCI and PnP
devices, because at least one IRQ must be available for PCI and PnP devices. The
settings are ISA/EISA or PCI/PnP. The Optimal and Fail-Safe default settings are
PCI/PnP.
DMA0/1/3/5/6/7 Assigned to
These options allow you to specify the bus type used by each DMA channel. The
settings are PnP or ISA/EISA
.
Advertisement
Table of Contents
