Table of Contents
Advertisement
Installation and Maintenance Manual
37
SAFETY INSPECTIONS AND MAINTENANCE
7 Safety Inspections
All security entrance equipment requires a simple daily safety inspection to ensure the system is
functioning properly. This test must be performed by the owner or facility manager. Should any
safety feature fail to pass the test, the unit must be disabled until repair is complete. It is
recommended that a simple log of such inspections is kept for security and safety purposes.
7.1 Daily Inspection
•
Visually inspect area for any trip hazards, sharp edges or other damage.
•
Inspect both incoming and outgoing traffic scenarios.
•
Inspect the entire unit for unusual noises.
•
Present a valid card and manually rotate the unit in the authorized direction(s).
•
Verify that traffic lights turn the appropriate colors (if equipped).
•
After rotation, the unit should position and lock.
8 Maintenance
For detailed troubleshooting information please refer to chapter 9 Troubleshooting.
8.1 Weekly Cleaning
It is recommended that a minimum weekly cleaning of the equipment be performed to assure
proper operation and optimal function.
•
Clean exterior finish with a damp cotton cloth. Special finishes can be damaged by
abrasive cleaning agents.
•
Wipe lens covers on cabinets with soft cloth to clean any buildup from obstructing
beams.
•
•
Clean optional lexan panels with soft cloth and mild soap. Do not use chemical or
abraisive cleaners on lexan units.
8.2 Semi-Annual Planned Maintenance
It is recommended that a minimum of two planned maintenance inspections be performed on
the equipment by an Authorized Boon Edam agent to assure proper operation and optimal
function.
General Inspection
•
The technician should report to a contact and always ask if there are any particular
issues with the units.
•
Make sure to write down any remarks made by the customer on the checklist.
•
Perform a visual check for broken materials (sharp edges) or other damages.
•
Check the whole unit for unusual noises.
•
Check the details of the location on the maintenance checklist (product type, product
no.).
•
Remove the top channel cover to gain access to the control mechanism and electronics.
•
Always check out with contact and/or reception.
Version : 10//28/2011
Issue
: THT-100-IMM-USA REV A6
Hide quick links:
Advertisement
Table of Contents
