Mechanical Assembly - BOON EDAM THT-100 Operation, Installation, And Maintenance Manual

Installation and Maintenance Manual
23

5.7 Mechanical Assembly

Base Plate
Center the Base Plate over the Center Point Mark as shown in Figure 4.3.
Base Plate holes to the flooring. Using a hammer drill and 3/8" bit, drill holes for anchor bolts
into flooring surface.
Center
Point
Shield and Barrier Assemblies
The outside edge of the shield and outside edge of the barrier assemblies layout on the floor
markings with the appropriate lines as designated in Figure 5.2. Using a hammer drill, drill and
anchor the 3/8" bolts at the six mounting hole locations as illustrated in Figure 5.1. Stand the
barrier and shield and tighten in place as shown in Figure 5.4 using the 3/8" nuts and Flat
washers.
2x
Anchor
Secure
Version : 10//28/2011
Issue : THT-100-IMM-USA REV A6
Secure
Non-Secure
Figure 5-4: Bearing Plate
Non-Secure
Figure 5-5: Shield and Barrier Anchoring
Mark through the
Parts Used in this Process
Qty Part #
1 100-039E
3 HW055
3 HW056
3 HW057
4x
Anchor
Hardware Used in this Process
Qty Part # Description
3/8" Red Head Anchor
6 HW055
Bolts
6 HW056 3/8" Flat Washer
6 HW057 3/8" Nuts
Description
Base Plate
3/8" Anchor Bolts
3/8" Flat Washer
3/8" Nuts