Audio Settings; General Settings - Primare I35 User Manual

AUDIO SettIngS

The AUDIO SettIngS menu allows you to customise the
balance and start-up volume, and the maximum and mute
volume.
AUDIO SETTINGS
BALANCE
STARTUP VOLUME
MAXIMUM VOLUME
BAlAnCe
Allows you to adjust the balance between 00LR-9 (far left),
00LR00 (centred, default) and -9LR00 (far right).
StArtUp VOlUme
Sets the general startup volume to between 0 and 60. The
default is 0.
mAXImUm VOlUme
Sets the maximum volume limit between 0 and 99. The
default is 99.
mUte VOlUme
Sets the volume when unit is muted. You can choose
between 0 (default) and 30.
If the current volume is lower than the specified mUte
VOlUme, the volume will be set to 0 when pressing mute.
DIgItAl OUtpUt
Allows you to choose the sample rate for analogue inputs
on the digital output as 96kHz (default) or 48kHz. For
digital inputs the output format is the same as the input.
I35 DAC Integrated Amplifier User Guide

generAl SettIngS

The generAl SettIngS menu allows you to configure the
general operation of the I35:
GENERAL SETTINGS
FRONT PANEL
0
AUTO-DIM
00LR00
LED BRIGHTNESS
30
99
SHOW InpUtS
Choose between All (default), to show all inputs, or WItH
SIgnAl, to show only inputs that have a signal.
frOnt pAnel
Choose lOCKeD to lock the front panel buttons and
knobs, or UnlOCKeD (default) to use them.
To unlock the front panel buttons use the remote control to
select this menu, or remove power from the I35 for a few
seconds.
AUtO-DIm
Allows you to choose the delay for dimming the display
after no user interaction, between: After 1mIn, After
5mIn, After 10mIn (default), or Off.
leD BrIgHtneSS
Displays the leD BrIgHtneSS menu to allow you to set the
display brightness to between 1 and 5 for each display
dimming level:
DIm HIgH (default 3), DIm mID (default ), DIm lOW
(default 1), or DIm Off (default 1).
StAnDBY SettIngS
Displays the StAnDBY SettIngS menu to allow you to
specify the standby settings.
StAnDBY mODe can be set to eCO to reduce the standby
consumption to less than 0.5W, but only allows the I35 to
wake from the analogue and digital inputs, or nOrmAl
which also allows the I35 to wake from the PC/MAC
input.
AUtO-StAnDBY automatically switches the I35 to
standby if there is no user interaction or audio from the
current source for a specified delay: After 10mIn, After
15mIn, After 20mIn (default), or Off.
fACtOrY reSet
0
UNLOCKED
Resets the I35 to the factory default settings.
AFTER 10MIN
You are prompted to confirm. Select YeS to proceed or
nO to cancel.
fIrmWAre VerSIOnS
Displays the fIrmWAre VerSIOnS menu to allow you to
view the versions of firmware installed.
13