Using The I35; Front Panel Controls; Changing The Volume; Selecting A Source - Primare I35 User Manual

U S I NG T H E I 3 5

front panel controls

Selector
Selects an input. In the settings menus navigates between
settings.
Standby O
Switches the I35 to standby, or switches it on from
standby.
menu @
Displays the settings menus or exits from the menus.
Select R
In the settings menus selects a setting or saves an edited
setting.
Back
In the settings menus navigates back or cancels editing a
setting.
Volume
Changes the volume.

Changing the volume

The I35 allows you to vary the volume from 0 (silence) to
99 (maximum).
to change the volume
Rotate the VOlUme control on the front panel, or press
l
the + or – buttons or the A or V buttons on the remote
control.
The current volume setting is shown on the front panel; for
example:
VOL 
10

Selecting a source

The I35 provides a choice of 1 inputs. Initially these are
labelled as shown in the following table, but you can give
them your own aliases to suit the sources in your system;
see ALIAS , page 1.
label Description
A1, A Balanced analogue on XLR
connectors.
A3–A5 Unbalanced analogue on RCA
connectors.
D6–D9 Digital optical on TOSLINK
connectors.
D10, D11 Digital coax on RCA connectors.
PC/MAC Digital on USB-B connector.
to select a source
Turn the SeleCtOr until the source is indicated on the
l
front panel display; for example:
A1
Alternatively, press the < or > buttons on the remote
l
control to step between sources, or enter 1 to 12 on
the remote control to select the corresponding source
directly.

Changing the display brightness

to change the front panel display brightness
Press the DIm button on the remote control to step
l
through the three levels of illumination and blank.
If you turn the display off it will be restored briefly when
you operate any control.
The display automatically dims after ten minutes; you can
adjust this delay in the settings menus; see GENERAL
SETTINGS , page 13.
I35 DAC Integrated Amplifier User Guide