Control Settings; Control; Audio Settings - Primare SP33 User Manual

Control SettinGS

Control

Allows you to configure hardware settings of the SP33
4KVM.
Option Description
OSD Set to YES to allow the video image
TRANSPARENT to show through the background of
the on-screen display, or NO to blank
the video image when the on-screen
display is displayed.
OSD POPUP Determines what information is
shown on the on-screen display when
changing source. FULL shows the
same information as the front panel
display, SIMPLE shows just the source
name, and OFF turns it off.
OSD POPUP Set to 1-10 sec to determine how long
TIME the on-screen display stays on the
screen.
OSD POPUP POS. Position of on-screen display.
VFD 1-3 to specify the front panel display
BRIGHTNESS brightness.
SP33 4KVM AV Preamplifier User Guide
Option Description
VFD DISPLAY If the front-panel display is blanked,
TIME sets the delay (1-10 sec) before the
display is blanked after operating any
control.
TRIGGER 1–3 See Trigger settings below.
REMOTE Select FRONT to use an infra-red
SELECT * remote control pointer at the front
panel, or BACK to control the SP33
4KVM using the IR input on the back
panel.
Select LOCKED to lock the front panel;
FRONT PANEL
you will then only be able to operate
the SP33 4KVM via the remote control.
Reset to UNLOCKED when you turn off
the SP33 4KVM at the back panel.
* Note: After changing this option you will not be able to
use the remote control to control the SP33 4KVM. To reset
this option operate the menus from the front panel.
Trigger settings
For each trigger you can set the following:
Option Description
TRIGGER 1–3 Specifies when the current trigger
is active: OFF, STANDBY to turn the
trigger off in standby, and on when
going out of standby, INPUT S to take
the setting from the INPUT SETTING
menu, or ZONE 2 to take the setting
from the ZONE 2 menu.
TRIGGER 1–3 Allows you to specify a delay of 0,
ON DELAY 1, 2, or 5 secs before the trigger is
activated.

AUdio SettinGS

The AUDIO SETTINGS menu allows you to specify options
affecting all audio outputs:
Option Description
LATE NIGHT Set to ON to apply dynamic range
compression to the audio, to reduce
loud transients for late night listening.
Set to ON to copy the bass from
DOUBLE BASS
speakers specified as LARGE and send
this to the subwoofer.
LFE LEVEL Can be adjusted between 0.0dB and -
10.0dB to reduce the LFE level.
VOLUME Determines the default volume (0 to
DEFAULT 99) when the SP33 4KVM is turned on
from standby.
1