Page 1
I35 DA C I nt eg r Ate D A mp l I f Ie r User Guide...
Page 2
E. the appliance has been dropped or the enclosure accessible. 2. Water and moisture damaged. Only connect the appliance to a power supply of the type The presence of electricity near water can be dangerous. I35 DAC Integrated Amplifier User Guide...
Page 3
1. This device may not cause harmful interference, and minimale de 0 cm entre le radiateur et votre corps. . This device must accept any interference received, The CE symbol indicates that this Primare product including interference that may cause undesired This device complies with Industry Canada licence-exempt complies with the EMC (Electromagnetic Compatibility) operation.
Additional information Selecting I35 mode Phase Fitting the batteries Burn-in RS232 and trigger Using the I35 Using the I35 with a CD35 Front panel controls Error messages Changing the volume Factory reset Selecting a source Changing the display brightness Index...
For additional support and assistance please contact your local authorized Primare dealer, or visit our website at www.primare.net. I35 DAC Integrated Amplifier User Guide...
A3, A, and A5 using high quality RCA cables. any cables. Digital inputs Note that the I35 is supplied with a protective film on the Switch on the I35, using the switch on the back panel. display glass. Remove the film for a clearer whiter display.
Optical Slot for Coax USB-B Digital network module digital inputs digital inputs input output On/off Balanced Unbalanced Analogue Power and RS232 Trigger Right Left in/out analogue inputs analogue inputs outputs speaker speaker fuse I35 DAC Integrated Amplifier User Guide...
Press and hold to switch all Primare products to standby Indicators light when to make the remote control operate the I35 pressing a button Press the Amp AV button once. Top: AMP, PRE, or CD mode Bottom: AV, SC, or AUX mode...
Changing the volume control to step between sources, or enter 1 to 12 on the remote control to select the corresponding source The I35 allows you to vary the volume from 0 (silence) to directly. 99 (maximum). to change the volume Rotate the VOlUme control on the front panel, or press the + or –...
Select the primare USB Audio DAC as the sound output device in the Mac Sound system preferences panel or Connect the source via a suitable cable: Connect the Mac or PC to the I35 via a USB-A to the PC Sound control panel. USB-B cable.
Fixed gain functions as an SSP (Surround Sound Pass- The renAme InpUt menu is displayed: Press the R button on the front panel, or the SeleCt through) allowing the I35 to be used as an amplifier in a button on the remote control. RENAME INPUT multi-channel system setup The current value is shown highlighted.
0. To unlock the front panel buttons use the remote control to mAXImUm VOlUme select this menu, or remove power from the I35 for a few Sets the maximum volume limit between 0 and 99. The seconds. default is 99.
x RCA 19kHz/ bit 1 x USB-B up to 76kHz/3 bit; up to DSD56 (11.MHz) Digital output 1 x RCA Analogue input = selectable between or 96kHz Digital input = native output I35 DAC Integrated Amplifier User Guide...
These instructions help you get the best possible sound from your I35. Your I35 is an ideal companion to the Primare CD35 CD Press and hold the O standby button on the front panel to Player. For best results link the two products together as display the main firmware version number.