Audio Settings; General Settings - Primare PRE60 User Manual

To give an alias to a source
•
Highlight the Alias item, then press the R button on
the front panel, or press the SELECT button on the
remote control.
The alias editor is displayed:
Input settings vol 22
5 6 7 8 9 A B C D E F
•
Turn the SELECTOR control on the front panel, or the
< or > buttons on the remote control, to select the
first letter.
•
Press the R button on the front panel, or the SELECT
button on the remote control, to select it:
Input settings vol 22
7 8 9 A B C D E F G H I
7 8 9 A B C
•
Repeat for the remaining letters.
•
Press the button on the front panel.
The source will be displayed with your alias:
Input settings vol 22
Input
Status Enabled
Alias CD
Source offset
1

Audio SEttinGS

The Audio settings menu allows you to customise the
start-up volume and balance, set when you turn the
PRE60 on from standby, and the maximum volume.
To set the start-up balance
Set the Balance setting to the balance you want to use:
To set the start-up volume
Set the Volume default setting to the volume you want to
use:
To set the maximum volume
Set the Volume max setting to the highest volume you
want to allow:
2
0
Audio settings vol 22
Balance 00 LR 00
Volume default 20
Volume max 79
Audio settings vol 22
Balance 00 LR 00
Volume default 30
Volume max 79
Audio settings vol 22
Balance 00 LR 00
Volume default 20
Volume max 60
PRE60 Audiophile Preamplifier, dAC, Streamer user Guide

GEnERAl SEttinGS

The General settings menu allows you to change the IR
input, and reset the PRE60 to the factory default settings.
To set the IR input
•
Set the IR input to Front to control the PRE60 using a
remote control pointed at the front panel, or Back to
control it via the IR-input on the back panel:
General settings vol 22
Media Auto Alias On
IR input Front
Factory DF Reset
After setting it to Back you can reset it to Front by
operating the settings menu from the front panel
controls.
To reset to the factory default settings
Warning: This will reset any source settings and aliases
you have defined.
•
Highlight the Factory DF item and press the R button
on the front panel, or the SELECT button on the
remote control, to select it.
You will be prompted:
General settings vol 22
Confirm factory DF
Yes No
•
Turn the SELECTOR control on the front panel, or
press the V button on the remote control, to highlight
Yes.
•
Press the R button on the front panel, or the SELECT
button on the remote control, to proceed and reset the
PRE60.
Alternatively, if you choose not to reset, highlight No and
press the R button on the front panel, or the SELECT
button on the remote control, to select it.