Advanced Operation; Repeater Operation; Checking The Repeater Uplink (Input) Frequency - Yaesu FTM-3200DR Operating Manual

Repeater Operation

The FTM-3200DR includes the ARS (Automatic Repeater Shift) function which permits
communication through repeaters automatically, by simply setting the receiver to the
repeater frequency.
1. Tune to the repeater frequency.
2. Press the PTT to transmit.
During transmission, radio waves having an 100.0 Hz* tone signal are emitted on the
frequency lower than reception frequency by 5 MHz*.
*: Depends on the transceiver version.
Note: From the Setup Menu, you can change the repeater setting.
RPT ARS 36
RPT FREQ 37 à Allows changing the repeater shift frequency offset.
RPT SFT 38

Checking the Repeater Uplink (Input) Frequency

It often is helpful to be able to check the uplink (input) frequency of a repeater, to see if
the calling station is within direct ("Simplex") range.
To do this, just press the [ REV ( DW )] key. You'll
notice that the display has shifted to the repeater
uplink frequency. Press the [ REV ( DW )] key
again to cause operation to revert to normal
monitoring of the repeater downlink (output)
frequency. While you are listening on the input
frequency to the repeater using the [ REV ( DW )]
key, the repeater offset icon will blink.
FTM-3200DR Operating Manual
à Deactivates the ARS function.
à Allows setting the repeater shift direction.
Application for FCC / IC
FCC ID: K6620523X50 / IC: 511B-20523X50

Advanced Operation

Blinks
19