Smeg CWC 611 User Manual page 19

10 TROUBLESHOOTING
How to deal with any problems without calling the after-sales service
PROBLEM
Led 6 does not light up
Washing program does not
start
Poor washing results
Inadequate rinsing
Stains on glasses and cutlery
Water in tank after pump-out
Dishes not properly dried
CWC 611
POSSIBLE CAUSE
Mains power failure
The dishwasher has not yet finished
filling.
Spray arm washing holes blocked by
dirt or limescale
Filter fouled
Too little or unsuitable detergent or
rinse aid.
No or not enough detergent or rinse
aid being supplied: detergent or rinse
aid not being taken from the relative
container.
Plates/glasses badly arranged
Low washing temperature
Inappropriate programme set
Dynamic pressure of mains water
insufficient
Spray arm nozzles fouled
Limescale in boiler
Rinse aid unsuitable or not being
delivered correctly.
Water hardness above 12°f or large
amounts of dissolved salts
Drain hose incorrectly positioned or
partially obstructed.
Low rinsing temperature due to
Thermostop OF and/or water intake
temperature below 50°
Check electrical mains connection.
Wait for the end of the "FILL" phase
Remove spray arms and clean them (routine
checks).
See "Cleaning the filter during the day"
Check type and quantity of detergent.
Check that the intake filter is not fouled. If you are
unable to solve the problem, call the after-sales
service.
Arrange plates/glasses correctly.
Check tank temperature shown on the display, call
the after-sales service if less than 50°C
Increase wash programme duration, especially if
dirt has dried on.
Check mains water pressure. Check that water
intake filter is not fouled. Clean rinsing nozzles.
If you are unable to solve the problem,
call the after-sales service.
Check container of rinse aid and whether it is
suitable for the type of mains water. If the problem
persists, contact the after-sales service.
Check that the dishwasher hose and drain are
unobstructed and the drain is not too high up; see
connection diagram.
Check that the water supplying the
appliance is at least at 50°
Rinse aid being delivered properly
If the problem persists call the after-sales service.
19
POSSIBLE REMEDY