Smeg CWC 611 User Manual page 17

Plates
TOTAL PUMP-OUT AT THE END OF THE DAY
After a total pump-out the filters should be cleaned as described in the relevant point.
Never switch the dishwasher off with water in the tank; always pump out first. Models with softener: if the
set number of cycles (see point 6.8 of the "technical manual") is reached, regeneration is carried out as well
as the pump-out; the entire process lasts about 15', after which the appliance switches off automatically.
Resin regeneration (for models with water softener)
Once the set number of wash cycles (see point 6.8 of the "technical manual" is reached), the Led above the
Therefore, during the working day resin regeneration must be carried out, following the procedure described below. There are
2 regeneration modes.
Topping up with regenerating salt (for models with softener)
Warning: use only salt of the specific type, do not use cooking salt.
Salt must be added when the Led underneath the symbol shown in the box on the left lights up. Top up with salt
when there is no water in the tank to prevent washing water from getting into the water softener device. The
salt tank has a capacity of about 1 kg of coarse-grained salt. The salt tank is in the bottom of the appliance's tank.
After removing the basket, undo the cap and pour the salt in using the funnel supplied. Remove any salt residues
around the opening before screwing the cap back on.
CWC 611
Plates
The basket is able to take 12 soup plates or 18 dinner plates.
Remove solid residues (bones, fruit peel, stones, etc.) and first soak
plates with dried residues of cheese, egg, etc. in water.
Press the pump-out button
pump-out and automatic tank cleaning phase starts. The word
"UnLoad" scrolls across the display. If the Led does not flash, the
program has not been started and the boiler heating element is not on.
When pump-out is complete the appliance switches off (only 2 dots lit
on the display)
1) ON REQUEST
Press the button for 5" to
regeneration phase starts. It lasts about 10 minutes, during which time
the Led keeps flashing. (Regeneration cannot be interrupted).
2) AT THE END OF THE DAY
Start the total pump-out and the appliance will perform regeneration
before emptying.
When pump-out is complete the appliance switches off (only 2 dots lit
on the display)
17
for about 5", the Led flashes and the
start regenerating; the Led flashes and the
button flashes.