Icom IC-M25 Instruction Manual page 21

Setting TAG channels
You can quickly recall often-used channels by tagging them
as TAG channels.
TAG channels can be independently assigned to each chan-
nel group (USA, International and Canada).
q Hold down [U/I/C] (CH/WX) for 1 second to change the
channel group, if needed. Repeat to go to the next group.
w Select the desired channel you want to set as a TAG channel.
e Hold down [*] (FAV) for 1 second.
" appears on the display.
To select a TAG channel:
Push [FAV] (*) several times to select the desired TAG
channel.
channels are skipped.
To clear a TAG channel:
q Select the desired channel you wan to clear the tagging.
w Hold down [*] (FAV) for 1 second.
" disappears.
To clear all TAG channels:
While holding down [*] (FAV), turn ON the power.
Setting the Call channel
You can recall the most often-used channel with a single op-
eration, by setting the channel as a Call channel.
A Call channel can be set in each channel group.
q Hold down [U/I/C] (CH/WX) for 1 second to change the
channel group. Repeat to go to the next group.
w Hold down [9] (16) for 1 second to recall the current Call
channel in the selected group.
CALL" and the Call channel number appear.
e Hold down [9] (16) again for 3 seconds (until a long beep
changes to 2 short beeps) to enter the Call channel set-
ting mode.
r Push [Y] or [Z] to select the new Call channel.
t Push [9] (16) to set.
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
13