Table of Contents
Advertisement
5.1.4.4
Opening and Closing the AP-IFU Cover
To open the cover:
(1)
Loosen the special screws
(2)
Fix the cover using the stopper
To close the cover:
(1)
Fix the stopper
(2)
Close the cover and tighten the special screws
CAUTION: When opening the AP-IFU cover, make sure that the four special screws are loosened
completely. Forcing open the cover may damage it.
CAUTION: After you opened the AP-IFU cover, make sure to secure it using the stopper. Otherwise,
you may get hurt. To close the cover, be sure to return the stopper to the original position.
CAUTION: If it is difficult to tighten the four special screws of the AP-IFU cover, adjust the locations
of the screw holes (support the cover and align the top of the cover to that of the chassis) and tighten
the screws. Forced tightening of the screws may damage the cover and screws.
CAUTION: When closing the cover, be careful not to nick cables.
to
as shown in Figure 5-9.
on the main unit as shown in Figure 5-9.
Figure 5-9Opening and Closing the AP-IFU Cover
Use a T25 torx driver to open the AP-IFU
cover.
to open the cover as shown in Figure 5-9.
to
as shown in Figure 5-9.
5-25
Advertisement
Table of Contents
