Connecting The External Puller 95-256 400-90 With Dc Motor - Pfaff 8320-020 Instruction Manual

Input
11

Connecting the external puller 95-256 400-90 with DC motor

.05.04
● The puller is activated via the parameter Enable puller = 1.
● The puller is activated (
● The optional closing cylinder closes the puller rollers when the puller is activated.
74
A modifi ed controller can be ordered under the Item No. 71-750 002-62. (the
order must contain the note "to be used with puller")
The puller button will then be displayed at the top right of various screen pages.
The puller will be opened or closed in parallel with the welding rollers when
parameter LinkRollerPuller = 1.
● PFAFF 8320 can optionally be equipped
with a puller.
● This puller is also retrofi ttable.
● An optional closing or lifting cylinder
must be connected via an additional
valve to X12/3 (+24V) and X12/4 (GND).
) and deactivated (
If the puller is retrofi tted, con-
troller PCS2002 will have to
be modifi ed. A 0.2 ohm SMD
resistor (e.g. a jumper) must
be soldered over the adjacent
Sense resistors R82 and R38.
This task must only be carried
out by authorised specialist
personnel.
Example 1
) via the puller button.