List Of Parameters - Pfaff 8320-020 Instruction Manual

13

List of parameters

.15.02
Sequence
continue
Enable
Manprog
VQLIM
Powertest
Stop with IN1
Start with IN2
Temp sensors
Flow control
Enable Puller
LinkRollerPuller
Only appropriately trained personnel is authorized to alter the set values
in the parameters!
0: Process sequence program as quick key selection.
1: Sequence programs are automatically relayed.
0: Manual data records cannot be saved or loaded.
1: Manual data records can be saved and loaded as
programs in area 130..149.
(see chap. 11.05)
if positive: error #17 boundary stress
if negative: max. stress at standstill
Only on the 8320-010
0: function deactivated
1: display of heating input at hot wedge
0: IN1 as zone forwarding condition in programs
1: digital Stop signal at input IN1
0: IN2 as zone forwarding condition in programs
1: digital Start signal at input IN2
Only on the 8320-020
Number of temperature sensors
0: function deactivated
1: Air volume monitoring
Option
0: No additional puller installed
1: Additional puller activating
Only visible with active puller
0: Puller is lifted or lowered with puller button
1: Puller follows the movement of upper roller
Adjustment
0 - 1 1
0 - 1 0
+/- 2400 500
0 - 1 0
0 - 1 0
0 - 1 0
1 -2 1
0 - 1 0
0 - 1 0
0 - 1 0
103