Change The Recall Time - Binatone Eclipse Plus User Manual

Note: After confirming the handset you want to remove on either the
Main Eclipse Handset or the additional handset,
•
A confirmation tone is played to indicate successful
deregistration.
PLS REG H/S is displayed on the home screen of the
•
deregistered handset.
•
During steps 1-5, i f no handset key is pressed within 10
seconds, the procedure will abort and the handset returns to
standby mode.

10.4 Change the Recall Time

You may need to press
(additional handsets) to send a Flash signal (also called Recall or
Timed Break Recall) if you are connected to a PBX or using certain
network services. You should normally leave the Recall Time at its
default setting, LONG(600ms), as this is the standard recall required in
the UK telephone network. However, it can be changed to Medium
(270ms) or SHORT(100ms) if your telephone is connected to a PBX that
requires a different recall time.
- On Your Main Eclipse Handset
1. From the home screen, press
+
2. Press
+
3. Press
+
4. Press
M
press
• A confirmation tone is played.
O
5. Press
- On Your Additional Handset
1. From the home screen, press
2. Press
T
or
-
/ to SETTINGS and then press
-
/ to RECALL TIME and then press
-
/ to select SHORT, MEDIUM or LONG and then
to confirm.
to return to standby mode.
+ -
\
F
(main Eclipse handset) or
M
.
M
.
to SETTINGS and then press
64
M
to select.
M
to select.
M
to select.
or