Note: If the answering machine is OFF and the SECURITY CODE is still set
at its default 0000, the answering machine will not answer any incoming
calls. However, if the SECURITY CODE has been changed, it will answer
incoming calls after 14 rings to allow remote access, and the
announcement will play. (See Remote Access on page 76.)
11.2 Answering Machine Settings
11.2.1
Set the Ring Delay
You can select the number of rings before the answering machine
answers a call and starts playing the announcement.
You can set the delay from 2 to 7 RINGS or TOLL SAVER on the Main
Eclipse Handset or TOLL SAVER on the additional handset.
IMPORTANT: If your network voice messaging system is enabled, you
must set your RING DELAY to less than 6 rings; otherwise the network
service will answer all your calls before the answering machine of your
telephone and prevent it from recording any messages.
-
On Your Main Eclipse Handset
1.
From the home screen, press
M
2.
Press
+
3.
Press
M
4.
Press
+
5.
Press
then press
•
A confirmation tone is played.
O
6.
Press
-
again to select ANS. SYSTEM.
-
/
to ANS. SETTING and then press
to select RING DELAY.
-
/
to select 2 RINGS – 7 RINGS or TOLL SAVER and
M
to confirm.
to return to standby mode.
M
.
68
M
.