Checking The Codes; Checking Device Codes - Universal Electronics MediaRemote User Manual

Media Remote Rev 1.fm Page 13 Monday, October 3, 2005 4:12 PM
4. Enter the device group number (see
"Device Table" on page 8)
5. Aim the remote control at the
device and press PWR (or PLAY, if
the device does not have a power
button) once.
Press CH+. If the device turns off or
6.
begins playing, the remote is now
programmed for the device. If the
device does not respond, repeat this
step until it does.
NOTE: In the search mode, the remote
control will send IR codes from its
library to the selected device,
starting with the most popular code
first.
NOTE: You can use CH - to go back a code
if you bypass the code you want.
Press OK once to lock in the code.
7.
The power key will blink twice.
To search for the codes to assign to other
devices, repeat steps 1 through 7, but
substitute the key (e.g., TV, CBL/SAT, or
AUDIO) you want to use to control the
device.

CHECKING THE CODES

NOTE: If more than 10 seconds pass
between key presses, the remote
exits programming.

Checking Device Codes

If you have set up theMediaRemote with
SimpleCenter by searching for your
device code (above), you may need to
find out which five-digit code is
operating your equipment.
For example, to find out which code is
operating the device you programmed for
the TV key:
1. On the remote control, press TV
once; the power key blinks once.
2. Press and (rewind and fast
forward) at the same time until the
power key blinks twice.
Enter 9 9 0. The power key blinks
3.
twice.
4. To view the code for the first digit,
press 1 once. Wait 3 seconds and
count the number of times the
power key blinks (e.g., 3 blinks = 3)
13