Checking The Codes; Using Learning - Universal Electronics Potenza ST Manual

CHECKING THE CODES

If you have set up your remote control by searching for your device code (previous section), you may need to find out
which four-digit code is operating your equipment. For example, to find out which code is operating your TV:
1. On the remote control, press TV once; it will blink once. Then press and hold SETUP until the TV key blinks
twice.
2. Enter 9 9 0 . The TV key will blink twice.
3. To view the code for the first digit, press 1 once. Count the number of times the TV key blinks (e.g., 3 blinks =
3) and write down the number in the left most TV Code box above.
NOTE: If a code digit is 0, the selected mode key will not blink.
4. Repeat step 3 three more times for the remaining digits. Use 2 for the second digit, 3 for the third digit, and 4
for the fourth digit. Finish writing down the code in the TV Code boxes above
5. To check for other device codes, repeat steps 1 through 4, but substitute the appropriate key (e.g., TV, AUD,
DVD, AUX, or STB ) for the device you are checking. Write down the codes in the appropriate boxes above.

USING LEARNING

The Potenza ST Universal Remote Control includes a Learning feature (not available on all models) so you can add
functions that are unique to your home entertainment devices (e.g.,VCR Tracking Up or Down).
However, there are some considerations.
Learning Precautions
• Your original remote controls must be in working order for learning to work properly.
• Learned keys are mode-specific, so each one can store a unique function for each mode.• Do not use the following
keys for learning:
• Learning capacity is approximately 16 to 25 keys, depending on the code being learned.
• Certain device functions are not learnable including multi-frequency types, some high frequency ones, and other
unusual formats.
• For optimum learning, avoid high levels of ambient light such as natural sunlight or energy-efficient fluorescent
lights.
• Please have your original remote controls
Programming a Learned Key
NOTE: If more than 15 seconds pass between key presses, the remote exits programming.
1. Press and hold
NOTE: If the LED displays one long flash instead, either your batteries are low, or the Potenza ST
Universal Remote Control has a memory fault.
2. Press a mode key once (i.e., TV, AUD, DVD, AUX, or STB ) to assign a mode for learning.
3. Press the desired key on the Potenza ST once to store the feature to be learned.
4. Place the Potenza ST Remote Control head-to-head (about 2" apart) from your original remote control . Also
locate the key (on your original remote control) that you want the Potenza ST Universal Remote Control to learn.
5. On the original remote, press and hold the key to be learned. The Potenza ST Remote Control's LED will blink
Device Keys, SETUP, Record (•), Tune-In Keys .
NOTE:
SETUP until the last-selected mode key blinks twice, then press 9 7 5 .
handy before programming learning.
10