Checking The Codes - Universal Electronics Potenza ST User Manual

NOTE:
In the search mode, the remote control will
send IR codes from its library to the selected
device, starting with the most popular code
first.
Press POWER. The TV should turn on, then
6.
press SETUP once to lock in the code. The LED
will blink twice to indicate that the code is
saved.
NOTE:
If the TV does not turn on during step 6, then
slowly press and release CH- to go back
through the codes, then press SETUP when the
TV turns on.
7. To search for the codes of your other devices,
repeat steps 1 through 6, but substitute the
appropriate key (e.g., VCR, DVD, AUD, or STB)
for the device you are searching for.

CHECKING THE CODES

If you have set up your remote control by searching for
your device code (on the previous page), you may need
to find out which four-digit code is operating your
equipment.
For example, to find out which code is operating your TV:
On the remote control, press TV once; it will
1.
blink once. Then press and hold SETUP until
the TV key blinks twice.
2. Enter 9 9 0. The TV key will blink twice.
To view the code for the first digit, press 1
3.
once. Count the number of times the TV key
blinks (e.g., 3 blinks = 3) and write down the
number in the leftmost TV Code box on
page 11.
NOTE: If a code digit is 0, the selected mode key will
not blink.
4. Repeat step 3 three more times for the
remaining digits. Use 2 for the second digit, 3
for the third digit, and 4 for the fourth digit.
Finish writing down the code in the TV Code
boxes on page 11.
5. To check for other device codes, repeat steps 1
through 4, but substitute the appropriate key
(e.g., VCR, DVD, AUD, or STB) for the device
you are checking. Write down the codes in the
appropriate boxes on page 11.